DLS FlexxPump 250 B Quick Start

Display in LCD Description
Submenus
INF INF-menu
b41 Firmware version of the FlexxPump 250 / 400 B
h03 Currently set value of break time h
c01 Currently set value of number of strokes c
06 Currently set value of emptying time Et
SET Set-menu
-h- Operating mode: hour mode
Et Operating mode: empty time mode
250 / 400 Setting for cartridge size
RUN RUN-menu
01...70 During the manually triggered active RUN com-
mand („quick check"/extra dispense), the LCD
displays the approximate back pressure in bar. In
addition, the green LED lights up.
PRO PRO-menu
h1...240 Adjustable setting of break time h
c1...30 Adjustbale setting of number of strokes c
01...36 Adjustabe setting of emptying time Et
FIL FIL-menu
01...70 During the manually triggered active FIL command,
the LCD displays the approximate back pressure in
bar. In addition, the green LED lights up.
Clr If the process is aborted during the FIL command,
Clr appears at first.
Additional characters on the LCD
1 / 2 During a dispensing process the FlexxPump 250
/ 400 B indicates from which outlet lubricant is
being pumped.
MAX After each cycle the maximum back pressure is
displayed in bar.
5.3 Actions with the activation and programming key
1. Turn the activation and programming
key to the OPEN position and remove it
from the housing of the FlexxPump 250 /
400 B.
2. Place the key on the action area on
the front of the FlexxPump 250 / 400 B.
3. Remove the key from the action
area as long as the desired menu item is
displayed in the LCD.
5.4 SET menu
The SET menu allows you to change the operating mode of the
FlexxPump 250 / 400 B. You can switch between hour mode -h- and
empty time mode -Et-.
-h- Operating mode: hour mode -h-
ET Operating mode: empty time mode Et
If you would like to change the operating mode, move the activation
and programming key back to the action area.
When your desired operating mode is displayed on the LCD, remove
the activation and programming key from the action area.
5.5 PRO menu
Being in operating mode hour mode -h-, you can change the break
time h as well as the number of cycles c (number of strokes).
Being in PRO menu the first step is to set the break time h and after-
wards the number of cycles c; direct access to the number of cycles c
is not possible.
Being in empty time mode Et, you can change the emptying time Et
in months as well as the number of cycles c.
5.6 FIL menu
This function enables you to prefill connected accessories (tubes,
distri-butors,...) with the lubricant contained in the lubricant cartrid-
ge, especially during the initial start-up of the FlexxPump 250 / 400
B. However, the process can also be aborted manually at any time.
6. Maintenance
Notice
It is not possible to refill empty or opened lubricant cartridges.
Notice
The battery of the FlexxPump 250 / 400 B must be replaced at the
same time as the lubricant cartridge.
Rev.: SG-20210914
QuickStart
FlexxPump 250 / 400 B