Table of Contents
Advertisement
2.
Camera Cabling
Please follow the instructions below to complete IP Camera connection.
2.1
Connect Power
Please refer to
camera's PoE port and plug the other end of the cable into a PoE switch.
in the network.
2.2
Connect
Use of Category 5 Ethernet cable is recommended for network connection; to have best
transmission quality, cable length shall not exceed 100 meters. Connect one end of the
Ethernet cable to the RJ-45 connector of the IP Camera, and the other end of the cable
to the network switch or PC.
when connecting the IP Camera directly to the PC.
Check the status of the link indicator and activity indicator LEDs; if the LEDs are unlit,
please check LAN connection.
2.3
Connect Alarm I/O
The camera equips one alarm input and one relay output for alarm application.
Please refer to the label on the alarm terminal block and connect the alarm wiring ac-
cordingly.
8
Section:
Connectors. Alternatively, connect the Ethernet cable to the
NOTE: If using PoE, make sure Power Sourcing Equipment (PSE) is in use
Ethernet Cable
NOTE: In some cases, you may need use an Ethernet crossover cable
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
Advertisement
Table of Contents
