Table of Contents
Advertisement
2.
Camera Cabling
Follow the instructions below to complete IP Camera connection.
2.1
Connect Power
For power connection, please refer to section Connectors. Alternatively, users
can power the camera by PoE. Refer to the section below to connect the Ether-
net Cable for PoE connection.
2.2
Connect Ethernet Cable
Use of Category 5 Ethernet Cable is recommended for network / PoE
connection. For best transmission quality, cable length shall not exceed 100
meters. Connect one end of the Ethernet Cable to the RJ-45 connector of the IP
Camera / Function Cable, and plug the other end of the cable to the network
switch or PC.
Check the status of the link indicator and activity indicator LEDs. If the LEDs are
unlit, please check the LAN connection.
8
NOTE: If PoE is used, make sure Power Sourcing Equipment (PSE) is
in used in the network.
NOTE: In some cases, Ethernet Crossover Cable might be needed
when connecting the camera directly to the PC.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
Advertisement
Table of Contents
