Advertisement
ETH
Port
Step 4: Connect Fiber
C
CAUTION
LASER RADIATION
1310 nm to 1600 nm
Do not view directly with optical instruments.
This product contains a Class 1M Laser module that complies
with 21 CFR 1040.10 and 1040.11 and IEC 60825-1 and -2.
Fiber is installed in an SC/APC connecter located behind a
removable protector panel on the right-rear of the Small Form
Factor ONT. Refer to the figures below and the following steps to
install fiber:
1. Remove the Protective Panel and slide it back (in the direc-
tion of the dashed arrow) to expose the SC/APC connector.
Fiber
Port
2. Refer to the illustration below and pull the Protective Cover
from the SC/APC Connector.
Protective
Cover
3. Clean the ends of the Incoming Fiber and the SC/APC
Connector.
4. Refer to the illustration at the top of the next column and
connect the Incoming Fiber to the SC/APC Connector.
Incoming
Fiber
61287565G1-22B
Protective
Panel
SC/APC
Connector
5. Route the fiber cable through the slot in the Protective Panel.
6. Replace the Protective Panel on the Small Form Factor ONT,
and secure it with the retaining screw.
NOTE
When the SC/APC fiber connection is not in use, replace the
Protective Cover. This will help keep the optical connection clean.
Step 5: Connect Power
Refer to the following illustration and steps when connecting
power and turning the Small Form Factor ONT On and Off.
1. Plug the supplied 12 V AC/DC Power Converter into the
PWR connection on the rear of the chassis.
2. Connect the power plug to a standard 120 V AC outlet.
RESET
Button
Power
On/Off
ON/OFF Button
An On/Off button is located on the back of the Small Form Factor
ONT.
LED S
TATUS
The LEDs are located beneath the plastic housing and are only
visible after power has been applied. The following table provides
the LED status during normal operations.
Label
Status
PWR
Off
Green
GPON
Off
Green
2
Green Flashing
OPTICAL
Off
Red
2
Red Flashing
LAN
Off
Green
2
Green Flashing Fast
Indication
ONT power is Off
ONT power On
ONT is not active
ONT is active
ONT is activating
ONT is receiving optical power
normally
ONT PON optical module
power is off
ONT receiving low optical
power
ETH Port not connected
ETH Port connected, but data is
not being transmitted
ETH Port connected, and data
is being transmitted
3
Advertisement
