Table of Contents
Advertisement
(2) A minimum 2G SD card is required to support DVR function, 16 GB recommended
or 32 GB SD card
(3) If motion is detected, it is recorded at normal speed (approx. 25 to 30f/s)
if no movement is detected, it is recorded at ahigherspeed (and 3f/s).
(4) If you set the start time and end time the same, the DVR function will work continuously.
16. Internal memory backup:
To back up all uploaded files from internal memory to SD
tab, press the Settings icon on the main menu, select Backup
internal memory, an icon will appear on the screen and it will be confirmed by a memory backup.
17. Set the ringtone:
Users can choose preset ringtones on the monitor or set
your own mp3 files as ringtones.
Procedure:
Create the "eRingTone" folder on the micro SD card and copy the mp3 files to the folder.
Insert the micro SD card into the monitor, press the "Settings" icon in the main menu
select the "Ringtone Sound" menu, then select the ringtone to open the door or
inthe intercom's yzving tone and choose the desired mp3 file.
18. System settings:
Set system time
Press the settings icon in the main menu and select System Time".
Time format : Day Month Year / Hours/Minutes/Seconds, after setting, press n
of the screen to confirm and save.
19. Password settings:
Password for system settings and settings.
Press the "Settings" icon in the main menu and select the "Password Protection" menu.
3 protection modes are possible:
(1) Unprotected : No password required for all settings
(2) Partial protection: You need to enter a password to set up your system. To access
you do not need to enter a password on the settings menu.
(3) Full protection : A password is required to enter system settings and settings.
Note:
(1) After selecting protection mode, you can set 4 local password default password is: 0000)
(2) To confirm the password entry" # "icon, press "* " to cancel the input.
20.Password protection of the list of entry stations.
If you enable any protection mode, you must edit the
the default password is "0" and you can set it as a password for system settings.
Instructions:
Press the settings icon in the main menu, select "Device Configuration", then List of Input Stations " and
select the desired input station, go to "Edit ", enter the default password "0" and confirm with the " # "
icon. Select "Password settings" and set a new password with 1 to 8 i
Note: If you are entering a password for the list of entry stations, you must enter a number that does not
have the first digit 0.
upper left corner
asset in the
numbers.
Advertisement
Table of Contents
