Chapter 5 Daily Care; Cleaning Materials; Cleaning The Scanner Exterior - Fujitsu ScanSnap S300 Getting Started Manual

Chapter 5 Daily Care

This chapter describes how to clean the ScanSnap.
WARNING

5.1 Cleaning Materials

Cleaning Materials
Cleaner F1
Cleaning wipe
*1) It may take long before the cleaner vaporizes if a large quantity is used. When
cleaning the scanner parts, dampen a cloth with modest quantities of the cleaner. In
addition, wipe off the cleaner completely with a soft lint-free cloth to leave no residue
on the surface of the cleaned parts.
*2) Pre-moistened with Cleaner F1, Cleaning Wipes are used instead of moistened cloths.
To purchase the cleaning material, contact the store where you purchased the scanner or
an authorized FUJITSU scanner service provider.

5.2 Cleaning the Scanner Exterior

Clean the scanner exterior with a cloth moistened with a small amount of neutral
detergent or Cleaner F1 (sold separately).
ATTENTION
• Before cleaning the scanner, turn the scanner OFF to prevent fire or
electric shock.
• To avoid injuries, do not place the internal parts (such as the Pad
ASSY and Pick roller) in areas where small children can reach.
Parts No.
PA03950-0352
PA03950-0419
• Never use paint thinner or other organic solvents.
• During the cleaning, prevent water or moisture from getting inside the
scanner.
• Do not use aerosol sprays to clean the scanner. Aerosol sprays cause
dirt and dust to enter the scanner, resulting in scanner failure or
malfunction, or errors in scanned images.
Remarks
1 bottle (100 ml) (*1)
1 pack (24 sheets) (*2)
ScanSnap S300 Getting Started
32