Installing Driver; Scanner Driver - Fujitsu FI-6130 Getting Started Manual

■ Installing the FUJITSU TWAIN32

Scanner Driver

HINT
Screenshots taken in Windows XP are used as examples.
The displayed windows and operations may slightly vary
depending on the operating system you are using.
1. Press the Power button to turn on the scanner.
2. Turn on your computer and log on to Windows.
ATTENTION
Be sure to log on as a user with "Administrator" privileges.
3. When the scanner is automatically detected, [Found
New Hardware Wizard] or [Add/Remove Hardware
Wizard] dialog box appears. Click [Cancel] to close
the Wizard dialog box.
4. Insert the Setup CD-ROM into the CD drive.
⇒
<SETUP DISK START UP SCREEN> appears.
ATTENTION
This screen may not appear if the "AutoPlay" setting is set to
off. In this case, find "Install.exe" in the CD-ROM using
"Explore" or "My Computer" to start installation.
5. Click [INSTALL PRODUCTS], and then click
[TWAIN Driver].
5
6. The Error Recovery Guide Installation dialog box
appears.
Error Recovery Guide is an application with which
you can view on-screen information for troubleshoot-
ing errors that may occur in the scanner. This guide
helps solve problems, so select [Yes] to install it. You
may also choose to install it later.
ATTENTION
After you select [Yes] for installing Error Recovery Guide, the
[Choose Setup Language] dialog box appears. Select a
language and follow the on-screen instructions. The Error
Recovery Guide dialog box is automatically displayed when
the installation is complete. Wait until the installation of the
TWAIN driver starts.
7. Select a language for the installation on the
[Choose Setup Language] dialog box, and then
click the [Next] button.
8. Install the driver, following the on-screen
instructions.
9. When you see the [InstallShield Wizard Complete]
dialog box, click the [Finish] button.
ATTENTION
•
Depending on the state of the operating system, the
computer may shut down and restart. In this case, the
computer detects the scanner when it starts up. Do not
remove the Setup CD-ROM from the CD drive until the
computer completely starts up again.
•
Depending on the operating system you are using, you
may need to do the following.
Windows 2000:
If you see the [Digital Signature not Found] dialog box,
click the [Yes] button.
Windows Vista:
If you see the [Found New Hardware] dialog box, select
[Locate and install driver software], and then in the
[User Account Control] dialog box, click the [Continue]
button, if it is displayed.
The installation of FUJITSU TWAIN 32 is complete. Next,
install ScandAll PRO ( page 7).