Black & Decker GST2000-B1 Manual page 9

7. Press the power switch. (Steam will emit
in 40-45 seconds)
Note: The amount of steam can be adjusted,
there are 3 di erent settings for steam
which can be set by pressing the on button
the required number of times:
NOTE:
• If the water level window shows green, it
means the tank has enough water.
• If the water level window shows red, it
means the tank has little water and you
need to refill the water tank.
• If the lamp (12) starts flashing and an
intermittent beep is heard, there is no
water in the appliance. Switch the
appliance o and remove the plug from
the mains. Refill the water tank.
Warning! After use and whenever you leave
the appliance for any amount of time, turn
the appliance o and remove the plug from
the mains.
Note: After use, turn the appliance o and
remove the plug from the mains then empty
the water from the appliance, do not leave
water in the appliance whilst it is being
stored.
Using the pleat maker
1. Fit the pleat maker.
2. Open the pleat maker by pulling the
handle towards the steam head.
3. Place the material between the pleat
maker and the steam head then release
the handle.
4. Move the steam head slowly along the
pleat in a downwards direction.
ENGLISH
9