Fujitsu FI-4340C Cleaning And Maintenance page 54

Is the scanner the last
device of the SCSI chain?
Is the SCSI ID set
correctly?
Is the baud rate of the
system 4800 bps?
(When you use the Fujitsu
video interface board.)
Is the CHECK indicator lit?
CHECK
Is an Alarm displayed?
Contact the manufacturer's authorized
service center.
G
4-6
NO
YES
NO
YES
NO
YES
NO
YES
The termination should be
turned off by the SCSI
terminator switch on the rear
of the image scanner.
Set the SCSI ID correctly.
Use the SCSI ID switch on
the rear of the image
scanner to change the ID.
Contact the manufacturer's
authorized service center to
set the correct baud rate.
The image scanner is
operating normally.