Advertisement
Quick Installation and Startup Guide
The Energy Manager should be mounted
10
near an Ethernet port which may be
located on a wall or at the router. The
Energy Manager also needs to be
plugged into a 120 Volt 50/60 Hz outlet.
12
Plug the power cord into a 120 VAC outlet.
Before plugging in the Ethernet cable,
confirm that the ports are live.
The serial number is
located on the inside
cover of the Energy
Manager. Document the
serial number as this
will be required when
provisioning the system.
TESTING THE ENERGY MANAGER INTERNET CONNECTION
14
1. Go to www.mywebcomfort.net
2. In the "Log" box, enter the following:
a. the serial number which is located under the inside cover
(Mac address) of the Energy Manager
b. "admin" for password
3. Click "Log in".
4. If asked to change your user name, click "Remind me later"
After removing the cover, position and secure the antenna using the conduit nut attached to the antenna wire.
11
Make sure that the antenna is positioned as shown in the illustration. Mount the Energy Manager on a vertical
surface that is close to both the 120 VAC outlet and Ethernet ports and replace the cover.
13
15
.
PRE-STARTUP CHECKLIST
1. Power up all thermostats.
2. Power up the Energy Manager.
.
3. Confirm that Energy Manager to plugged
into a live internet port.
4. If a firewall is blocking the Energy Manager
from communicating to the internet, make sure
the following ports are open. These ports need
to be open for communication. These are UDP
ports and they are outbound.
a. 54260
b. 59368
c. 59369
An IT professional may be required to open ports.
COMMUNICATIONS CONFIRMATION
1. Communications is confirmed if under Status the word Active is displayed.
Launch will also be displayed under Live Link.
Dashboard
Settings
Display Information from:
11/01/2012
to:
12/01/2012
Status
Alerts
Premise
Active
0
Customer Location
Location Address
*
Details
+
Register New Manager
2. Click Launch. The username is admin The password is password
3. If the word Error is displayed under Status, internet communications is not connected.
Revisit 13 of the Installation Guide
4. Change default password
5. Refer to 5.4.2 in user manual to start adding thermostats
Welcome, (Customer Name)
Viewer (Limited)
ShowHide Indicators
ShowHide Columns
Address
kWh
$/kWh
SqFt
Live Link
0
0.00
0
Launch
5418 Elmwood Avenue, Indianapolis, IN 46203-6025
Toll Free: 888.652.9663
Fax: 317.227.1034
www.jacksonsystems.com
06-1122-092920
Advertisement
