Advertisement
STEP 1: (VEHICLE PREP)
If installing multiple Curtis Polaris Ranger 1000 kits,
install in the following order.
1.Doors
2.Windshield
3.Rear Panel
4.Roof
If the vehicle's nets are not installed on your
vehicle, skip to Step 1.6 on the next page.
1.1 Per figure 1.1, remove left lower, mount-net and its
(2) mounting screws. Re-install screws into the
vehicle.
Tools required
Torque T40 wrench or socket
1.2 Per figure 1.2, remove left net clip and its (2)
mounting screws.
Tools required
Torque T40 wrench or socket
1.3 Per figure 1.3, remove (2) of the left net mounting
screws. The screws are located in the shoulder
restraint top mounting foot and the bottom of the
door opening. Re-install screws into the vehicle
with the net mount removed.
Tools required
Torque T40 wrench or socket
1.4 Per figure 1.4, remove hex flange mounting screw
at the shoulder restraint bottom mounting foot.
Re-install screw into the vehicle with the net mount
removed.
Tools required
13mm socket and wrench
1.5 Per figure 1.5, remove hex flange mounting screw
and hinge plate at the back of the ROPS.
The net is now free to be completely removed.
Tools required
13mm socket and wrench
Hinge Plate
Fig. 1.5 (Remove Top Left Net Mounting Screw)
KIT INSTALLATION
Fig. 1.1 (Remove Left Lower, Mount-Net)
Fig. 1.2 (Remove Left Net-Clip)
Mounting screw
Fig. 1.3 (Remove Left Net Mounting Screws)
Mounting screw
Fig. 1.4 (Remove Left Net Mounting Screw)
3 of 9
Mounting screw
Advertisement
