Advertisement
WARNINGS, TIPS, & REQUIRED TOOLS ...................................................... 2
KIT INSTALLATION ..................................................................................... 3-5
CAB FEATURES & OPERATION .................................................................... 6
CARE AND MAINTENANCE ........................................................................... 6
SERVICE PARTS ........................................................................................... 7
BOLT TORQUE SPECIFICATIONS ............................................................. 8-9
WARNINGS, TIPS, & REQUIRED TOOLS
Curtis cabs, kits, and accessories feature an assembly of parts designed for your vehicle which require
adjustment and alignment of components to accommodate vehicle variations and provide proper weather
protection. For accurate installation, proper operation, and years of satisfaction, please read and understand the
installation and owner's manual fully prior to installing the door kit.
From all of us at Curtis, we thank you for choosing our product.
ADDED
WEIGHT
Curtis Cabs, blades and general accessories
add additional weight to the base vehicle. All
Curtis accessory weights are listed in product
brochures. Deduct the accessory's total weight
from the vehicle's rated capacity and never
exceed the vehicle's rated capacity including
driver and passenger.
Exposure to Carbon Monoxide
can Cause illness, serious injury or
death.
Never operate vehicle if suspicious of Carbon Monox-
ide. Inspect exhaust system for leaks monthly. Leaks can
result from loose connections, corrosion, cracks or other
damage to the exhaust manifold. If leaks are found, repair or
replace exhaust system. Do not use vehicle until repair or
replacement is complete.
California Health and Safety Proposition 65 Warning: This product may contain chemicals
known to the state of California to cause cancer and birth defects or other reproductive harm.
GENERAL INFORMATION BEFORE YOU START
HELPFUL HINTS:
•
Refer to parts diagram found in the service parts section of this manual to help identify parts
during the assembly process.
•
To assist with the door installation, leave all fasteners loose for later adjustment unless otherwise
specified.
•
Read and understand all instructions before beginning.
•
Apply a silicone sealant to seal any minor gaps that may occur due to vehicle variations.
•
Before installing parts with factory installed rubber, make sure the rubber is fully installed onto the
parts for proper fit and sealing.
TOOLS REQUIRED:
•
Set of Standard and Metric Sockets (3/8" Drive)
•
3/8" Drive Ratchet and Long Drive Extension
•
Set of Standard and Metric Open-End Wrenches
•
Silicone Sealant
•
Drill/Driver
•
Torque T40 Wrench
TABLE OF CONTENTS
2 of 9
Advertisement
