Advertisement
STEP 1: (VEHICLE PREP, continued)
1.6 Use black silicone to seal the entire front ROPS
joint shown in Figure 1.6. Note: A significant
amount of water will enter the vehicle through
this seam if this step is not taken.
1.7 Repeat steps 1.1 to 1.6 on right side net assembly
STEP 2: (KIT INSTALLATION)
2.1 Per figure 2.1, install striker pin assembly on the
left side at the removed net-clip location. Use
provided M8 hex flange bolts.
Hardware Used
M8x1.25 X 30 Hex Head Flange Screw
Tools required
13mm socket and wrench
2.2 Per figure 2.2, install upper left hinge pin on the left
side ROPS . Use provided 5/16-18 hex flange bolts
and (1 of 4) hinge pin mounting plates.
Hardware Used
5/16-18 X 3/4 Hex Head Flange Screw
Tools required
1/2" socket and wrench
2.3 Per figure 2.3, install lower left hinge pin on the left
side ROPS . Use provided 5/16-18 hex flange bolts
and (1 of 4) hinge pin mounting plates.
Hardware Used
5/16-18 X 3/4 Hex Head Flange Screw
Tools required
1/2" socket and wrench
2.4 Install the supplied brass washers onto the hinge
pins on the left side and then apply grease to the
pins.
Fig. 2.3 (Lower Hinge Pin, Left)
KIT INSTALLATION
Qty
2
Qty
2
Qty
2
Fig. 1.6 (ROPS Joint)
Fig. 2.1 (Striker Pin Assembly, Left)
Fig. 2.2 (Upper Hinge Pin, Left)
4 of 9
Advertisement
