Advertisement
Quick Links
1 of 8
CLUB CAR CARRYALL
ROPS CAB
OVERHEAD CONSOLE
(w/ Fans)
p/n: 47587420001
Approximate Installation Time *
Experienced Dealer Technician – 30 Minutes
Average Dealer Technician – 45 Minutes
Do-It-Yourself – 1 Hour
(*=Not including accessories)
The contents of this envelope are the property of the owner. Leave with the owner when installation is complete.
Rev. F, 11/24/2020
p/n: IM-47587420001
Advertisement
Related Manuals for Curtis 47587420001
Summary of Contents for Curtis 47587420001
- Page 1 1 of 8 CLUB CAR CARRYALL ROPS CAB OVERHEAD CONSOLE (w/ Fans) p/n: 47587420001 Approximate Installation Time * Experienced Dealer Technician – 30 Minutes Average Dealer Technician – 45 Minutes Do-It-Yourself – 1 Hour (*=Not including accessories) The contents of this envelope are the property of the owner. Leave with the owner when installation is complete.
-
Page 2: Tools Required
For accurate installation, proper operation, and years of satisfaction, please read and understand the installation and owner’s manual fully prior to installing the console. From all of us at Curtis, we thank you for choosing our product TOOLS REQUIRED: #1 (small) Phillips screwdriver •... -
Page 3: Installation
3 of 8 INSTALLATION 1. Vehicle Preparation: 1.1 Installation of a Dome Light, Strobe Light, or Rear Work Light requires the removal of the plastic roof. If installing any of these accessories, remove the plastic roof as outlined in the accessory instructions. Note: If 7.5-amp fuse was installed in vehicle when installing wiper, switch back to 15-amp fuse. - Page 4 4 of 8 INSTALLATION 2.4 Slide a rubber grommet onto each wire from step Connection for 2.3 and install the grommet into the hole in the console roof. Console Wiring: 3.1 Unplug the cab power wire from the wiper motor. Connect the cab power wire to the short harness (without wire loom) inside console from the fuse block.
- Page 5 5 of 8 INSTALLATION Changing Fuse (For Gasoline Vehicles Only): Electronic component box NOTE: If you have the electric vehicle, skip this section and proceed to step 6. 5.1 Lift bed or remove seat in order to access electronic component box. 5.2 Remove the screw that secures the cover to the electronic component box in the compartment under the driver’s seat as shown.
- Page 6 6 of 8 OVERHEAD CONSOLE TROUBLESHOOTING Condition Possible Solution • All console lights are off • Vehicle Ignition Key is off • Check 15 Amp fuse • One switch light is off • Check fuse for that device (see below) •...
-
Page 7: Service Parts
7 of 8 SERVICE PARTS PART NUMBER. DESCRIPTION QTY. 8SV-FP01-B4 FUSE BLOCK, 6-POSITION WITH MOUNTING BRACKET 8SV-OHCFC-B4 FUSE COVER 9SV-OHC1 AXIAL FAN, 80mm X 80mm 9SV-LVR02 LOUVER VENT, 4” LOW-PROFILE 9SV-WHOHC1 WIRE HARNESS, FUSE BLOCK 9SV-WHOHC2 WIRE HARNESS, WIPER 9SV-WH-00030 WIRE HARNESS, BEACON LIGHT AND DOME LIGHT 9SV-WH-00031 WIRE HARNESS, WORK LIGHTS... -
Page 8: Bolt Torque Specifications
8 of 8 BOLT TORQUE BOLT TORQUE SPECIFICATIONS GENERAL TORQUE SPECIFICATION TABLE Use the following torques when special torques are not given. These values apply to fasteners as received from suppliers, dry, or when lubricated with normal engine oil. They do not apply if special graphited or moly disulphide greases or other extreme pressure lubricants are used.