Shop-Vac 6045 Series User Manual page 7

7. Slide basket adapters on handle. See images below for correct installation of adapters.
For 14" diameter tanks
Handle
8. Attach handle onto uprights by pushing down and holding buttons in on uprights.
9. Place tank retaining bracket through slot and bolt in rear frame and screw on knob.
10. Slide bumper down over main dolly frame until it bottoms out.
11. Place one hair pin clip in one end of axle. Slide one washer down the length of the axle to rest on the
hair pin clip. Slide wheel onto axle next to washer. Be sure flat side of wheel hub is facing outward.
Slide axle through holes in rear of frame and slide on other wheel. Before assembling hairpin clip to
other end of axle, be certain dolly is assembled correctly. (You may place tank on dolly and tighten knob
of retaining bracket to be sure of correct assembly.)
12. After ensuring dolly is assembled correctly remove tank and place dolly on side. Slide washer onto axle.
Insert hair pin clip into remaining hole in axle to hold wheel in place.
13. Place accessory basket on adapters and pull out on outer rim of basket
and snap into place.
5
6
23
2
15
14
16
5
19
17
15
CARRIAGE HANDLE
Follow the instructions for the carriage handle that came with your vacuum.
If your side tank handles look like the ones pictured to the right, follow these instructions.
ASSEMBLY (CONT'D)
Handle
1
4
23
3
15
7
11
10
13
12
5
9
21
24
15
8
18
ITEM NUMBER & DESCRIPTION
1. Handle
22
2. Handle upright
3. Handle brace
4. ¼ - 20 x 1¼" Hex head
machine screw (Black)
5. ¼" External tooth
lockwasher
6. ¼ - 20 Hex nut (Black)
7. Rear dolly frame
8. Main dolly frame
9. / - 18 x 2½" Hex head bolt
5
16
20
10. / " Split lockwash
5
16
11. / - 18 Hex nut
5
16
For 16" diameter tanks
Tank
Handle
Basket
Basket
Adapter
Pull Outward
on Basket
12. Tank retainer bracket
13. Threaded knob
14. Axle
15. ¼ - 20 x
16. ¼ - 20 Hex nut
17. Caster socket
18. Caster
19. Bumper
20. 10" Wheel (25.4cm)
21. Hair pin clip
22. Accessory basket
23. Basket adapter
24. Washer
Handle
Basket
Adapter
/ " Hex head
5
8
machine screw
PAGE 7