Table of Contents
Advertisement
S Series.book Page 58 Thursday, February 19, 2004 4:52 PM
L i f e B o o k S 7 0 0 0 N o t e b o o k
Problem
Keyboard or Mouse Problems
The built-in keyboard does
The notebook has gone into
not seem to work.
Suspend mode.
Your application has locked
out your keyboard.
You have installed an
Your external device is not
external keyboard or
properly installed.
mouse, and it does not
Your operating system
seem to work.
software is not setup with the
correct software driver
for that device.
Your mouse or keyboard is
connected to the wrong PS/2
port on the optional Port
Replicator.
You have connected an
Your operating system
external keyboard or a
software is not setup with
mouse and it seems to be
the correct software driver
locking up the system.
for that device.
Your system has crashed.
Memory Problems
Your Power On screen, or
Your memory upgrade module
Main menu of the BIOS
is not properly installed.
setup utility information,
does not show the correct
You have a memory failure.
amount of installed
memory.
Modem Problems
Messages about modem
Messages about modem
operation.
operation are generated by
whichever modem application
is in use.
Parallel, Serial, and USB Device Problems
You have installed a parallel
The device is not
port device, a serial port
properly installed.
device or a USB device.
The device may have been
Your LifeBook notebook
installed while an application
does not recognize the
was running, so your notebook
device, or the device does
is not aware of its installation.
not seem to work properly.
Your device may not have the
correct software driver active.
You may have the wrong I/O
address selected for your
device.
58
Possible Cause
Push the Power/Suspend/Resume button.
Try to use your integrated pointing device to restart
your system.
Re-install your device. (See Device Ports on page 50
for more information)
Check your device and operating system docu-
mentation and activate the proper driver.
Plug the mouse into the PS/2 Mouse port and
the external keyboard or numeric key pad into the
PS/2 Keyboard port. (See PS/2 Port on page 51 for
more information)
Check your device and operating system
documentation and activate the proper driver.
Try to restart your notebook. I
Remove and re-install your memory upgrade
module. (See Memory Upgrade Module on page 45
for more information)
Check for Power On Self Test (POST) messages.
(See Power On Self Test Messages on page 64 for more
information)
See your application software documentation for
additional information.
Remove and re-install the device. (See Device Ports
on page 50 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 29 for more information)
Possible Solutions
Advertisement
Chapters
Table of Contents
Troubleshooting
