Hard Drive Problems; Keyboard Or Mouse Problems - Fujitsu LIFEBOOK NH532 User Manual

Hide thumbs Also See for LIFEBOOK NH532:
Table of Contents

Advertisement

Available languages

Available languages

Problem
The drive access indicator on the
Status Indicator Panel blinks at
regular intervals with no disc in
the tray or the drive is not
installed.

Hard Drive Problems

You cannot access your hard drive.

Keyboard or Mouse Problems

The built-in keyboard does not
seem to work.
You have installed an external
keyboard or mouse, and it does
not seem to work.
You have connected an external
keyboard or a mouse and it seems
to be locking up the system.
Possible Cause
The Windows AutoPlay func-
tion is active and is checking
to see if a disc is ready to run.
Wrong drive designator was
used when a bootable disc
was used to start the system.
Security is set so your OS can-
not start without a password.
The notebook has gone into
Standby mode.
NumLock key is set.
Your external device is not
properly installed.
Your operating system soft-
ware is not set up with correct
software driver for that device.
Your operating system soft-
ware is not setup with correct
driver.
Your system has crashed.
Possible Solutions
This is normal. However, you may disable this feature by going to Control Panel >
AutoPlay.
Verify drive designator used by application is in use by the operating system.
When the operating system is booted from a CD, drive designations are
automatically adjusted.
Verify your password and security settings.
Push the Power/Suspend/Resume button.
Press the NumLock key to reset it.
See "Device Ports" on page 45.
Re-install your device.
Check your device and operating system documentation and activate the proper
driver.
Check your device and operating system documentation and activate the proper
driver.
Try to restart your LIFEBOOK notebook. If that fails, turn off the power using the
power/suspend/resume button, wait at least 10 seconds, and then power on. If
turning off power with the power/suspend/resume button fails, the button has
likely been set to suspend or hibernate. In that case, disconnect the power cord,
then remove and re-insert the battery.
73 - Troubleshooting

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents