Pc Card Problems; Power Failures - Fujitsu Lifebook S7010 User Manual

S Series.book Page 59 Thursday, February 19, 2004 4:52 PM
Problem
You have installed a parallel Your device and another device
port device, a serial port are assigned the same I/O
device or a USB device. address.
Your LifeBook notebook
Parallel port is set to output
does not recognize the
only.
device, or the device does
not seem to work properly.
(continued)

PC Card Problems

A card inserted in the PC The card is not properly
Card slot does not work or installed.
is locking up the system.
The card may have been
installed while an application
was running, so your notebook
is not aware of its installation.
Your software may not have
the correct software driver
active.
You may have the wrong I/O
address selected for your PC
Card device.
Your PC Card device and
another device are assigned the
same I/O address.

Power Failures

You turn on your The installed primary battery
LifeBook notebook and is completely discharged, there
nothing seems to happen. is no optional second battery
installed or there is no Power
adapter (AC or Auto/Airline)
installed.
The primary battery is
installed but is faulty.
The battery or batteries are low. Check the Status Indicator Panel to determine the
The power adapter (AC or
auto/airline) is not plugged
in properly.
Possible Cause
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check parallel port setting in the BIOS and set to
bi-directional or ECP.
Remove and re-install the card. (See PC Cards on
page 43 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your PC Card documentation to determine
the required I/O address. Change the settings in
the BIOS. (See BIOS Setup Utility on page 29 for
more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check the Status Indicator Panel to determine the
presence and condition of the batteries. (See Status
Indicator Panel on page 11 for more information)
Install a charged battery or a Power adapter.
Use the Status Indicator panel to verify the presence
and condition of the batteries. (See Status Indicator
Panel on page 11 for more information) If a battery is
indicating a short, remove that battery and operate
from another power source or replace that battery.
presence and condition of the batteries. (See Status
Indicator Panel on page 11 for more information) Use
a Power adapter to operate until a battery is charged
or install a charged battery.
Verify that your adapter is connected correctly. (See
Power Sources on page 27 for more information)
T r o u b l e s h o o t i n g
Possible Solutions
59