Gas Connection - Electrolux EOG 621 Instruction Booklet

Gas connection

Fitting the appliance and cabinet
The gas supply connection ramp is positioned in the front
upper side of the oven, behind the control panel.
To carry out the gas connection, partially insert the oven
in the recess (about 30 cm.) and operate on the
connection ramp from the top. The gas connection can
be carried out in both the following systems:
1) Fig. 6 — flexible metallic pipes (with maximum length
up to 2 metres only) — screw the feed pipe to the
1/2“ connection ramp, inserting the gasket provided
between the pipe and the ramp;
2) Fig. 7 — rigid metallic pipe (soft copper - minimum
diameter: 8 mm) — insert the copper pipe into the
connection ramp after fitting the correct nut and olive
onto the copper pipe using a male / female adapter
(not supplied).
To carry out the connection:
- tighten (fig.8) the nuts by means of a 22 mm. spanner,
in order to keep the ramp in position and not to cause
any distortion to the gas supply circuit.
- completely insert the oven in the recess and secure it
as indicated in the relevant paragraph.
Check the gas supply ramp and the gas
connection pipe are not squeezed while the
oven is positioned into the recess.
The use of rubber flexible hoses is not
permitted.
WARNINGS
• Using a gas cooking appliance will produce heat
and moisture in the room which it has been
installed in. Ensure a continuous air supply,
keeping the air vents in good conditions or
installing a cooker hood with discharge tube.
• In case of intensive or long time use of the
appliance, make the ventilation more efficient,
by opening a window or increasing the electric
exhaust fan power.
• Check the perfect sealing of the connection using
leak detection fluid.
18
All manuals and user guides at all-guides.com
Fig.6
FO 0671
nut
Fig.7
FO 0672
gas supply
ramp
Fig.8
FO 0673
flexible
metallic pipe
gasket
rigid
metallic pipe
olive
male / female
adapter
nut