Use this unit only for its intended use as denoted in this suction fitting. manual. DO NOT use attachments not recommended by the Kohler Co. Never drop or insert any object into any opening. DANGER: To reduce the risk of injury, do not permit children to use this unit unless they are closely supervised at all times.
Follow the sections that pertain Kohler Co. reserves the right to make changes in to your particular installation. This will aid you in avoiding product characteristics, packaging, or availability at any the unnecessary expense associated with improper time without notice.
Product Requirements. Kohler Co. shall not be liable under its warranty or NOTICE: Follow all local plumbing and electrical otherwise for personal injury or damage caused by codes.
K-852-JA-AA: The installation must have an Earth Leakage Circuit Breaker (ELCB). This will provide additional protection against line-to-ground shock hazard. A 230V, 50 Hz separate circuit that provides 15A of continuous service is required. Kohler Co., Kohler WI 111889- (1093)
4. Cap supplies and check for leaks. For replacement installations: remove old bath, remove old wall material and remove old floor covering from area. Remove old plumbing which does not conform to roughing-in requirements. 111889- (1093) Kohler Co., Kohler WI...
Bath can be installed as a corner, recess or sunken installation. Possible studding arrangements are illustrated in 1. through 3. below; modifications may be needed for other types of construction. Corner Installation: Suggested stud construction is illustrated. Kohler Co., Kohler WI 111889- (1093)
Instructions packed with the tiling-in bead. B. PARTIALLY INSTALL BATH DRAIN Install drain bath/whirlpool according manufacturer’s instructions. C. PROTECT BATH UNIT Place a drop cloth or similar material in bath/whirlpool bottom. Be careful not to scratch product. 111889- (1093) Kohler Co., Kohler WI...
K-1172 legs. These legs adjust about 3/4” in height adding a minimum of 2-3/4” and a maximum of 3-1/2” in height. For installation of the optional adjustable legs, refer to instructions packed with K-1172. Kohler Co., Kohler WI 111889- (1093)
Do not use a grounding adapter. Your Kohler Whirlpool bath is equipped with a cord and plug. All wiring of the pump and control has been completed at the factory. A licensed electrician must install a GFCI protected, 120 Volt, 15 Amp, grounded outlet.
Install finished wall material to subwall. Vinyl Tiling-In Bead Seal joints under bath rim and finished wall. Bath Rim Install finished floor. Caulk along bottom edge of apron with a water-resistant sealer. Kohler Co., Kohler WI 111889- (1093)
Plaster can be removed by scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. One of the powder-type detergents may be used on a damp cloth to provide mild abrasive action to the residual plaster. 111889- (1093) Kohler Co., Kohler WI...
A built-in timer automatically stops the motor after Add air to whirl- Reduce 20 minutes of operation. pool action, rotate flange counter- clockwise. To reduce air, turn clockwise. Shut off whirlpool. Restart whirlpool after 20 minute cycle is com- plete. Kohler Co., Kohler WI 111889- (1093)
C. TROUBLESHOOT WHIRLPOOL SYSTEM This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or a qualified electrician should correct all electrical problems. For warranty service, contact your dealer or wholesale distributor. SYMPTOMS PROBABLE CAUSES RECOMMENDED ACTION 1.