Starting The Programme; Soaking Laundry; Adding Laundry; Cancelling The Pro- Gramme - Siemens WG44G2MG0 User Manual And Installation Instructions

13.8 Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/Nachlegen.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: "-0-".
13.9 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start/
Nachlegen.
To resume the programme, after
3.
the desired soaking time, press
Start/Nachlegen.
13.10 Adding laundry
Press Start/Nachlegen.
1.
The appliance pauses.
appears, it is not pos-
Note: If
sible to add laundry.
When goes out, it is possible to
add laundry.
Open the appliance door.
2.
Add or remove laundry.
3.
Close the appliance door.
4.
Press Start/Nachlegen.
5.
13.11 Cancelling the pro-
gramme
Press Start/Nachlegen.
1.
Open the appliance door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Spülen programme.
– If the water level is high, start
the Schleudern programme or
select a suitable programme for
draining.
→ "Programmes", Page 24
Remove the laundry → Page 31.
3.
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Start the Schleudern programme
1.
or select a suitable programme for
draining.
→ "Programmes", Page 24
Press Start/Nachlegen.
2.
13.13 Unloading the laundry
Open the appliance door.
1.
Remove the laundry.
2.
13.14 Switching off the appli-
ance
Turn the programme selector to
1.
Basic operation en
.
31