Fujitsu Lifebook L440 User Manual page 171

P O I N T
Make certain you have your Operating
System Product ID# available (from the
Certificate of Authenticity) prior to per-
forming recovery. Once the process is
complete and you re-start your notebook,
you will be required to perform all the
setup steps as you did when the computer
was first bought. (See the section "Starting
Your Notebook For the First Time.")
Please locate and read any of the "Read-Me" files
on the CD. These files will provide information
that pertains specifically to the additional files
and utilities that are provided on the Recovery
CD for your particular LifeBook model.
P O I N T
To use this portion of the CD-ROM, your
notebook must BOOT (upon power up
of full system reset/restart) from the
CD-ROM drive. (See section four.)
T r o u b l e s h o o t i n g
To Run the Emergency Recovery Program
1. Insert the Recovery CD in the CD-ROM
drive.
2. If your notebook is running when you insert
the CD, exit your operating system and
power down the notebook.
3.Start (power up) your notebook.
4. At this point, you must either change your
BIOS setup configuration (F2 key) to have
the computer boot from the CD-ROM "first"
(if you have not previously done so), or use
the Esc key during the boot-up sequence and
select the CD-ROM from the menu which
will appear. For more information and
detailed instructions on changing the BIOS
setup, refer to Section Four of this manual.
5. If correctly configured to boot from the
Recovery CD-ROM, you will notice your
system will run a full virus scan of the hard
drive and then reach the Recovery CD
Welcome screen. If this is not what is dis-
played, check to see that the Recovery CD is
L i f e B o o k L S e r i e s f r o m F u j i t s u
installed in the CD-ROM drive and repeat
the previous steps (starting with 2).
Note: If you receive a message "This program
may not be used on your computer" you are
using the wrong Recovery CD for the model
of notebook.
6. Read the information displayed on the
Welcome screen, then Click OK.
7. Select one of the two icons displayed in the
Recovery CD menu and follow the instruc-
tions that follow.
8. When recovery is complete, remove the
Recovery CD, replace it in its sleeve and store
it in a safe location (with your Operating
System Manual/Certificate of Authenticity).
9. Restart your notebook.
10.Reset your boot device priority in the BIOS
setup as desired.
163