Sennheiser HSP 4 Instruction Manual
Hide thumbs
Also See for HSP 4:
- Instruction manual (77 pages) ,
- Instructions for use manual (29 pages) ,
- Bedienungsanleitung (29 pages)
Related Manuals for Sennheiser HSP 4
Summary of Contents for Sennheiser HSP 4
- Page 1 HSP 4 Model: HSP 4 HSP 4-3 HSP 4-ew HSP 4-ew-3 Bedienungsanleitung Instruction manual Notice d‘emploi Istruzioni per l‘uso Instrucciones de manejo Gebruiksaanwijzing...
-
Page 2: Important Safety Instructions
12. Do not use any solvents or aggressive cleaning agents to clean the product. 13. Caution: Very high signal levels can damage your hearing and your loudspeakers. Reduce the volume on the connected audio devices before switching on the product; this will also help prevent acoustic feedback. HSP 4 | 15... -
Page 3: Delivery Includes
It is considered improper use when the product is used for any applica- tion not named in the corresponding instruction manual. Sennheiser does not accept liability for damage arising from improper use or misuse of this product and its attachments/accessories. -
Page 4: Putting Into Operation
Putting into operation The HSP 4 is ready for operation on delivery. The microphone can be worn on the left or right side of the mouth. Attaching the microphone to the left or right side The neckband has as a clip which is designed so that the microphone boom can be worn on either side of the mouth. - Page 5 To reattach the microphone boom: First press the microphone boom and then the neckband into the clip as shown. Close the clip. 18 | HSP 4...
- Page 6 Push the microphone boom backwards or forwards in the clip so that the microphone is positioned directly at the corner of the mouth as shown. If necessary, precisely position the microphone by using the flexible gooseneck 3. HSP 4 | 19...
-
Page 7: Attaching The Sound Inlet Basket
Make sure not to cover the sound inlet. Adjusting the neckband The neckband is flexible and ensures an optimum fit. Change the length of the neckband until a snug but comfortable fit is achieved. If necessary, adjust the neckband at the earhooks. 20 | HSP 4... -
Page 8: Care And Maintenance
Reattach the sound inlet basket to the capsule so that it locks into place with an audible click. When attaching the sound inlet basket, make sure not to cover the sound inlet. HSP 4 | 21... - Page 9 Allow the connector and the socket to air dry for approx. 1 hour so that the remaining isopropyl alcohol can evaporate. Slide the silicone tube onto the connector. Connect the connector to the socket. 22 | HSP 4...
-
Page 10: Specifications
4.5 – 15 V Operating temperature -10 °C – +50 °C Cable length 1.6 m Diameter of boom arm 2 mm Weight 4.8 g Connector 3.5 mm mini-jack or 3-pin Neckband Width 110 mm Weight 4.4 g HSP 4 | 23... -
Page 11: Polar Pattern
60° 90° 90° 120° 120° 150° 150° 180° 180° 125 Hz 2000 Hz 250 Hz 4000 Hz 500 Hz 8000 Hz 1000 Hz 16000 Hz Frequency response 0°, 1 m 90°, 1 m 0°, 1 cm 24 | HSP 4... -
Page 12: Manufacturer Declarations
This warranty is in addition to other rights or remedies under law. Noth- ing in this warranty excludes, limits or modifies any remedy available to be consumer which is granted by law. To make a claim under this contract, raise a case via Sennheiser website Australia: https://en-au.sennheiser.com/service-support-contact New Zealand: https://en-nz.sennheiser.com/service-support-contact... -
Page 13: Eu Declaration Of Conformity
Further information on the recycling of theses products can be obtained from your municipal administration, from the municipal collection points, or from your Sennheiser partner. The separate collection of waste electrical and electronic equipment, batteries/rechargeable batteries (if applicable) and packagings is used to promote the reuse and recycling and to prevent negative effects caused by e.g. - Page 14 Sennheiser electronic GmbH & Co. KG Am Labor 1, 30900 Wedemark, Germany www.sennheiser.com Printed in Germany, Publ. 08/21, 527045/A03...