Table of Contents
Advertisement
IMPORTANT NOTE:
This model helicopter has been designed and produced to be a high performance 3D machine. With its simple design and low
parts count, pilots of all skill levels will appreciate its easy repairability. This is not a toy. Please take care assembling the model,
and take care and responsibility when you fly it. We take no responsibility for any damage or injuries, either direct or consequential,
from the use of this product. If you are not experienced in the assembly and flying of a high performance model helicopter we
recommend you seek the assistance of an experienced pilot. Above all, fly safely and we hope you enjoy this model.
SAFETY GUIDELINES:
Only fly this model in areas designated for the use of model aircraft. Ensure you obtain indemnity insurance, normally available
through your National model aircraft association. Remain at least 6 meters (20 feet) from the model at all times. Never allow
spectators or animals any closer than 30 meters (100 feet) from the model.
NOTES FOR ASSEMBLY:
Please read this instruction manual fully before beginning assembly of this model helicopter. Be sure to use quality tools during
the assembly process, and remember not to overtighten small fasteners. Note the following symbols which are used in this manual.
Use thread lock sparingly where indicated. If you are unsure about an assembly step, please seek the advice of an experienced
pilot. Warranty on any parts is only applicable prior to assembly of the part on the model.
NONE OF THE PRE ASSEMBLED PARTS HAVE THREAD LOCK ON THE SCREWS. IS IMPORTANT TO READ AND FOLLOW THE ASSEMBLY
NOTES IN EACH STEP. INCORRECT ASSEMBLY OR NOT USING THREAD LOCK WILL CAUSE A CRASH OR INJURY.
Important note
Use Loctite 648 Bonding
page 3
Use CA Glue
Use Silicone Grease
Chapter 2, Important Notes
Use Loctite 243 Medium Strength
Advertisement
Table of Contents
