Table of Contents
Advertisement
Canopy Mount Assembly
(Box 1-1/Bag 3)
Left Canopy
Mount Assembly
TBES1.6x5
Tapping Screw
Motor Pinion Installaion
Note: Output Motor Shaft
prepareration:
because OXY2 pinion have bonding
assembly follow below step for best results.
1- Sand Paper output shaft.
2- Use bonding compound
(Loctite 648 or Lynx LX5648).
Don't use STD lock thread.
3- After Install wait at least 10h before fly.
Output Shaft
to prepare
Motor Installation
OXY2 support two size of motor fitting
(13mm/M2 and 19mm/M2.5),
choose the correct holes
dependig on the used Motor.
Use Hex Cap Screw M2x5 for 13mm holes
Use Button Head Screw M2.5x5 for 19mm holes
page 15
OXY0260-
Canopy Mount
Break
Away Canopy support
mount
Kit Pionion
11T ID
2mm
(Box 1-1/Bag 4)
Loctite 648
Use bonding compound
Loctite 648 or LX5648,
don't use standard lock thread
Chapter 7: Main Frame Assembly
Right Canopy
Mount Assembly
Loctite 243
TBES1.6x5
Tapping Screw
after install wait
until 10h before fly
OXY0238-
Motor Mount
(Box 1-1/Bag 4)
Advertisement
Table of Contents
