Wall-Mounted Remote Control Tc-R Plus - Ferroli JOLLY Plus 2 User Manual

General start-up
In order to control the device from the control panel, it first has to be connected to mains. If the power line is provided
with a main switch, it should be on .
- Start the system by toggling the main switch
Activation
To activate the device
Key Operation
Press the ON stand-by key
Select one of the 4 operating modes by pressing the relative key .
Heating / cooling operating mode set-up
Key Operation
Press the Heating / Cooling key for about 2 seconds to switch between heating and
cooling operating modes; the selection is shown by 2 heating on or cooling on symbols
that will light up .
In heating, the symbol is alight when the setpoint is higher than the room temperature,
both are switched off when the setpoint is lower .
In cooling, the symbol is alight when the setpoint is lower than the room temperature,
both are switched off when the setpoint is higher .
Stand by
Key Operation
Press the ON stand-by for about 2 s: When the device is in "stand-by" status (no
function) there are no light signals on the display .
When the control is in this operating mode, the anti-freeze safety is secured . If the room temperature drops below
5°C the hot water solenoid valve and boiler go-ahead outputs activate .
Temperature selection
Key Operation
Use the two increase and decrease keys to set the desired room temperature displayed
on the 3 digit display .
The adjustment range goes from 16 to 28 °C, with a resolution of 0 .5 °C, but the system also allows the out of range
values 5 °C, ma sono consentiti anche i valori fuori scala di 5 °C and 40 °C (except when in auto mode) .
These values should be set only for short periods of time, the selection should then be adjusted to an intermediate value .
The control is very precise, set it to the desired value and wait for it to run the adjustment based on the actually
detected room temperature .
12

WALL-MOUNTED REMOTE CONTROL TC-R PLUS

Display
From off to on
Display
Display
Off
Display
20 .5