Fujitsu Lifebook E335 Manual page 31

C A U T I O N
Never turn off your notebook during
Power On Self Test (POST) or it will
cause an error message to be displayed
when you turn your notebook on the
next time. (See the Troubleshooting
information on pages 170-172.)
Booting the System with Windows 95
We strongly recommend that you not attach
any other external devices and do not put any
CD or floppy disk in your drives until you have
gone through the initial power on sequence.
When you turn on your notebook for the first
time it will display a Fujitsu logo on the screen.
If you do nothing the system will read the hard
drive for the operating system software, flash
the notebook configuration information on the
screen, and load the Windows 95 Setup Wizard.
You will then be stepped through the condition
of use process. You must complete this initial
process before you will be able to use your
S t a r t i n g Y o u r L i f e B o o k E S e r i e s
notebook. (If you wish to access the BIOS setup
utility before you go through the condition of
use process you must press the F2 key while the
Fujitsu logo is still visible. If you press the Esc
key while the Fujitsu logo is still present you
will get a dialog box which will allow you to
select which drive is to be used for finding the
operating system.) If you turn off the power
without using the on screen Cancel button
you will get an error message when you start
your notebook again.
Condition of Use Process
The first time you start your notebook you
must confirm your acceptance of the copyright
limitations for your pre-installed software. After
you complete the Condition of Use process
these screens will not appear again. There are 6
screens to read carefully and respond to.
You cannot use your notebook until this
Condition of Use process is completed. The
bottom of each screen has a <Back button, a
Next> Button and a Cancel button which
are activated by the integrated ErgoTrac or
L i f e B o o k E S e r i e s f r o m F u j i t s u
TouchPad cursor control and button click. The
<Back button will return you to the previous
screen. The Next> button activates any
choices or information you have entered and
takes you on to the next screen. The Cancel
button allows you to stop the setup process.
If you stop the process your notebook will
start up at the beginning of the Windows 95
Setup Wizard.
The screens you will be required to respond to
are described with the required action.
User Information
Fill in your name and your company name as
you want the software licensed. To step from the
name blank to the company blank press the Tab
key. When the information has been entered click
on the Next> button. You will not be allowed
to continue until you make an entry.
License Agreement
Read the agreement carefully. You can scroll
through the text using the integrated ErgoTrac
or TouchPad pointing device to activate the
17