Ethernet Lines; Mouse Or Keyboard; External Monitor; Theft Prevention Lock - Fujitsu Lifebook E335 Manual

ETHERNET CABLES
To attach an Ethernet cable to your internal
LAN card, locate the RJ-45 connector on the
left side of your notebook. Plug one end of the
Ethernet cable into your LAN (see your systems
administrator if you are unsure). Orient the
Ethernet cable with the release latch on the con-
nector down. Push it into the RJ-45 connector
until it clicks and latches.
MOUSE, KEYBOARD OR KEYPAD
Make sure the connector on your device is
the correct PS/2 type. Align the arrow on the
connector to point to the bottom of your note-
book and push it in until the connector seats.
A mouse, keyboard or keypad may be installed
and automatically recognized by your notebook
without restarting or changing setups.
(See Figure 1-8 on page 9.)
U s e r I n s t a l l a b l e

EXTERNAL MONITOR

You may install an external monitor on the
external monitor port on the rear panel of your
notebook. Make sure that the wide side of the
connector is up and attach it to the port by
pushing in until it is seated, then tighten the
hold-down screw on each end of the connector.
(See Figure 1-9 on page 10.)
C A U T I O N
Pressing F10 while holding down the Fn
key allows you to change your selection
of where to send your display video. Each
time you press the combination of keys
you will step to the next choice. The
choices, in order, are: built-in display panel
only, external monitor only, or both built-in
display panel and external monitor.
L i f e B o o k E S e r i e s f r o m F u j i t s u
F e a t u r e s

THEFT PREVENTION LOCK

A physical security system lock can be installed
on the right side of your notebook. (See Figure
1-8 on page 9 for the location of the lock slot.)
Simply insert the key end of your security
system in the slot, rotate 90 degrees and lock.
(See Figure 1-8 on page 9.)
139