Fujitsu Lifebook E335 Manual page 156

S e c t i o n F i v e
7. Align the memory upgrade module with
the part side up. Align the connector edge
of the memory upgrade module with the
connector slot in the compartment. The
connector will be pointing toward the rear
of the notebook. (Figure 5-13.)
Figure 5-13 Installing a Memory Upgrade Module
8. Insert the memory upgrade module at a
45° angle. (Figure 5-13.) Press the connector
edge of the module firmly down and into
the connector.
142
9. Press the memory upgrade module down
into the compartment until it lodges under
the retaining clip. You will hear a click when
it is properly in place.
10. Replace the cover by hooking the tabs
under the rear edge of the compartment
opening and tilting down until flush with
the bottom of your notebook.
11. Replace the screws.
The memory upgrade module is not something
you routinely remove from your notebook.
Once it is installed, you can leave it in place
unless you want to increase system
memory capacity.
C A U T I O N
Before you install or remove the memory
upgrade module, save changes and close
all files and turn power off to your note-
book. (See Power Off on pages 24-25.)
Figure 5-14 Removing a Memory Upgrade Module
To Remove a Memory Upgrade Module:
1. Perform steps 1 through 5 of To Install a
Memory Upgrade Module.
2. Pull the clips sideways away from each side
of the memory upgrade module at the same
time. (Figure 5-14.)
3. While holding the clips out, remove the
module from the slot by lifting it up and
pulling towards the front of your notebook.
(Figure 5-14.)