Fujitsu Lifebook E335 Manual page 179

Problem
The system powers up, and displays
power on information, but fails to load
the operating system.
T r o u b l e s h o o t i n g
Possible Cause
2. You did not hold the button in long enough.
3. There may be a conflict with the
application software.
1. The boot sequence settings of the setup utility
are not compatible with your configuration.
2. You have a secured system requiring a
password to load your operating system.
3. Internal hard drive was not detected.
L i f e B o o k E S e r i e s f r o m F u j i t s u
Possible Solution
2. Hold the button longer. This may need to
be a few seconds if your application is
preventing the CPU from checking for
button pushes.
3. Close all applications, and try the
button again.
1. Set the operating source by pressing the Esc
key while the Fujitsu logo is on screen or use
the F2 key and enter the setup utility and
adjust the source settings from the Boot
menu on page 103.
2. Make sure you have the right password.
Enter the setup utility and verify the
Security settings and modify them as appro-
priate. (See Security Menu on pages 101-106.)
3. Use the BIOS setup utility Main menu,
Primary Master submenu to try to auto
detect the internal hard drive.
165