Shutdown And Startup Problems - Fujitsu LifeBook B-2562 User Manual

L i f e B o o k B S e r i e s – S e c t i o n F i v e
Problem
Your LifeBook notebook
turns off all by itself.
(continued)
Your LifeBook notebook
will not work on battery
alone.
The battery seems to
discharge too quickly.

Shutdown and Startup Problems

The Suspend/Resume
button does not work.
56
Possible Cause
You have a battery failure.
Your power adapter has failed
or lost its power source.
The installed battery is dead.
No battery is installed.
The battery is improperly
installed.
Your installed battery is faulty.
You are running an application
that uses a great deal of power
due to frequent hard drive
access or CD-ROM access, use
of a modem card or a LAN PC
card.
The power savings features
may be disabled.
The brightness is turned all
the way up.
The battery is very old.
The battery has been exposed
to high temperatures.
The battery is too hot or too
cold.
The Suspend/Resume button
is disabled from the Advanced
submenu of the Power menu
of the setup utility.
You did not hold the button
in long enough.
There may be a conflict with
the application software.
Possible Solutions
Verify the condition of the battery using the
Status Indicator panel, and replace or remove
any battery that is shorted. See "Status Indicator
Panel" on page 13.
Make sure the adapter is plugged in and the outlet
has power.
Replace the battery with a charged one or install
a Power adapter.
Install a charged battery.
Verify that the battery is properly connected
by re-installing them.
Verify the condition of the battery using the
Status Indicator panel and replace or remove
any battery that is shorted. See "Status Indicator
Panel" on page 13.
Use both the primary battery and an optional
second battery and/or use a power adapter for this
application when at all possible.
Check the power management and/or setup utility
settings in the Power Savings menu and adjust
according to your operating needs.
Turn down the brightness adjustment. The higher
the brightness the more power your display uses.
Replace the battery.
Replace the battery.
Restore the notebook to normal operating tempera-
ture. The Charging icon on the Status Indicator
panel will flash when the battery is outside its
operating range.
Enable the button from the setup utility.
Hold the button longer. This may need to be a few
seconds if your application is preventing the CPU
from checking for button pushes.
Close all applications and try the button again.