Shutdown And Startup Problems - Fujitsu LIFEBOOK NH532 User Manual

Problem
Your LIFEBOOK notebook will not
work on battery alone.
(continued)
The battery seems to discharge
too quickly.

Shutdown and Startup Problems

The Suspend/Resume button does
not work.
The system powers up, and dis-
plays power on information, but
fails to load the operating system.
Possible Cause
No battery is installed.
Battery is improperly
installed.
The installed battery is faulty.
You are running an applica-
tion that uses a lot of power
due to frequent hard drive or
optical drive access, or use of
a WLAN or Bluetooth device.
The power savings features
may be disabled.
The battery is very old.
The brightness is turned all
the way up.
The battery has been exposed
to high temperatures.
The battery is too hot or too
cold.
Suspend/Resume button is
disabled.
Possible software conflict.
Your system is secured, requir-
ing a password to load the OS.
Boot sequence settings of the
setup utility are not compati-
ble with your configuration.
Possible Solutions
Install a charged battery.
Verify that the battery is properly connected by re-installing them.
Verify the condition of the batteries using the Status Indicator panel and replace
or remove any batteries that are shorted.
Use both the primary battery and an optional second battery and/or use a power
adapter for this application when at all possible.
Check the Power Options menu settings and adjust according to your operating
needs.
Replace the battery.
Turn down the brightness adjustment. The higher the brightness the more power
your display uses.
Replace the battery.
Restore the notebook to normal operating temperature. Charging icon on the Sta-
tus Indicator panel will flash when battery is outside of operating range.
Enable the button by going to the Control Panel > Power Options Properties.
Select "Choose what the power button does" option.
Close all applications and try the button again.
Make sure you have the right password. Enter the setup utility and verify the Secu-
rity settings and modify them as accordingly.
Set the operating source by pressing the [ESC] key while the Fujitsu logo is on
screen or use the [F2] key and enter the setup utility and adjust the source set-
See "BIOS Setup Utility" on page 37.
tings from the Boot menu.
76 - Troubleshooting
See "Status Indicator Panel" on page 19.
See "BIOS Setup Utility" on page 37.