Beamz LCB-48IP Quick Start Manual page 5

DMX Address – Set the DMX address
Press MENU, press the UP or DOWN button until "Addr" is displayed, press ENTER.
"Axxx" will now be displayed, ("xxx" represents the displayed address). Press the UP or DOWN button
to find the desired address. Press ENTER to confirm
Channel mode – Select the desired channel mode
Press MENU, press the UP or DOWN button until "Chnd" is displayed, press ENTER
"X Ch" will now be displayed, ("X" represents the displayed channel mode). Press the UP or DOWN
button to find the desired channel mode. Press ENTER to confirm.
Auto mode – This menu will let you select the desired auto mode.
Press MENU, press the UP or DOWN button until "Auto" is displayed, press ENTER.
There are 3 auto modes, press the UP or DOWN button to select the desired mode, press ENTER to
confirm.
Color mode – Select the desired color mode
Press MENU, press the UP or DOWN button until "CoLo" is displayed, press ENTER.
"Colx" or ATF will now be displayed, ("X" represents a number between 1 – 9). Press the UP or DOWN
button to find the desired color mode. Press ENTER to confirm.
ATF: Make your own color by mixing and adjusting the Red, Blue and Green color.
Slave mode – In this mode the unit functions as a slave
Press MENU, press the UP or DOWN button until "Slav" is displayed, press ENTER.
"Sla" will now be displayed, Slave mode is confirmed. The unit will now act as a slave in Auto, sound
and chase mode.
Version – Will display the software version of the unit.
Press MENU, press the UP or DOWN button until "ver" is displayed, press ENTER.
The software version of the unit will be displayed. Press MENU to leave this function
Operation Instructions
DMX connection.
Master / Slave connection.
- 5 -