Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Stanley FATMAX FMCW210
Summary of Contents for Stanley FATMAX FMCW210
- Page 1 FMCW210...
- Page 3 Charging Fully Charged Hot/Cold Pack Delay Bad Battery...
-
Page 5: Intended Use
3. Personal safety a. Stay alert, watch what you are doing and use common Your Stanley Fat Max FMCW210 sander has been designed sense when operating a power tool. Do not use a for sanding wood, metal, plastics and painted surfaces. This... - Page 6 ENGLISH (Original instructions) e. Maintain power tools. Check for misalignment or Never service damaged battery packs. Service of binding of moving parts, breakage of parts and any battery packs should only be performed by the other condition that may affect the power tools manufacturer or authorised service providers.
-
Page 7: Residual Risks
(Original instructions) ENGLISH Safety when sanding paint Vibration The declared vibration emission values stated in the technical Warning! Observe t he applicable regulations for sanding paint. Pa y special attention to the data and the declaration of conformity have been measured in accordance with a standard test method provided by following: Whenever possible, use a vacuum extractor for dust col-... -
Page 8: Electrical Safety
The performance of your tool depends on the accessory used. Charging procedure (Fig. A) Stanley Fat Max accessories are engineered to high quality Stanley Fat Max chargers are designed to charge Stanley Fat standards and designed to enhance the performance of your Max battery packs. -
Page 9: Important Charging Notes
(Original instructions) ENGLISH Bad Battery It is recommended that the batteries be recharged after each use. If you see a bad battery blink pattern, do not continue to charge this battery. Return it to a service center or a Leaving the battery in the charger collection site for recycling. -
Page 10: Maintenance
FMCW210 Sander not use any abrasive or solvent-based cleaner. Protecting the environment Stanley Europe declares that these products described under "technical data" are in compliance with: Separate collection. Products and batteries 2006/42/EC, EN60745-1:2009+A11:2010, EN60745-2- marked with this symbol must not be disposed of 4:2009+A11:2011 with normal household waste. - Page 11 ENGLISH (Original instructions) Australia & New Zealand St Stanley Black & Decker www.blackanddecker.com.au www.blackanddecker.co.nz Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ)
- Page 12 N597325 04/2018...