Advertisement
STEP
4.
(Receiver Address) If receiver is enabled, enter the two-digit receiver
address. (00-30).
Note: Refer to the control panel's installation instructions for the
acceptable receiver addresses.
Press the [] key to continue.
5.
(House ID) This prompt will only appear if the receiver is disabled. If the
receiver is enabled the 6160RF will use the House ID programmed in the
panel. Refer to Application Guidelines section when selecting a House ID.
To program a House ID: Enter 01-31.
To disable the transmitter: Enter 00
Note: Each device that will receive status from the 6160RF must be set
to the same House ID as the 6160RF (refer to Application
Guidelines section).
Press the [] key to continue.
6.
(Enable High Security Mode) Enter [1] to select High Security Mode.
Note: If the High Security mode is enabled, the 6160RF will only
recognize encrypted devices. If this mode is disabled, the
6160RF will process commands both encrypted and non-
encrypted devices.
Press the [] key to continue.
7.
(Disable High Security Devices) Press the [] key to skip this prompt and
exit Program Mode.
Notes: (1) The [] key must be pressed several times in order to save
the programmed data.
(2) If you need to disable encrypted devices, refer to the
Disabling High Security Devices section.
ACTIVATING HIGH SECURITY DEVICES
This following procedure should be followed if using High-Security (encrypted) devices.
STEP
Follow the normal procedure for programming the device into the control panel (refer to the Installation Instructions for
1.
the device that you are programming). Exit out of Programming Mode.
2.
Put the control panel in Go/ No Go Test mode. (See the Installation Guide for the panel being installed.)
Follow the instructions supplied with each wireless device to enroll the device in High-security mode. After each device
3.
is enrolled the 6160RF will momentarily display "SECURE DEVICE" along with the device number and its serial
number.
Note: The 6160RF will support a maximum of 8 devices. If you attempt to enroll additional devices the keypad will display
"EXCEEDED NUMBER" "ALLOWED DEVICES".
DISABLING HIGH SECURITY DEVICES
This mode gives you the ability to disable high security on all wireless keys that have been enrolled in the 6160RF. This is
particularly useful if a user loses a wireless key.
Once high-security (encrypted) devices have been disabled, they will only operate if the 6160RF is set to listen to both
encrypted and non-encrypted devices (programming step 6, above). To completely disable the devices, they must be deleted
from the control panel.
STEP
1.
After the keypad has been powered for at least 60 seconds hold down
the [1] and [3] keys at the same time for 3 seconds. The current keypad
address will be displayed. (You cannot change the keypad's address at
this point.) Press the [] key to continue.
2.
(Delete High Security Devices) Press the [1] key to remove all high-
security (encrypted) devices. Press the [] key to continue.
If YES was selected in Step 2 the unit will display a confirm request to
3.
delete the stored high security device. Press the [1] key to accept,
followed by the [] key to exit the programming mode.
DESCRIPTION
DESCRIPTION
DESCRIPTION
- 3 -
DISPLAY
REC ADDRESS=
XX
HOUSE ID =
XX
HIGH SECURITY
OFF [1] = ON
DISABLE HS
DEV?
NO [1] = YES
DISPLAY
CON ADDRESS=XX
DISABLE HS DEV?
NO [1]=YES
ARE YOU SURE?
NO [1]=YES
CHOICES
00-30
00-31
1= Enable
0 = Disable
1= YES
0 = NO
CHOICES
00-31
1= YES
0 = NO
1= YES
0 = NO
Advertisement
