Advertisement
Table 1 - Wiring Table
Keypad
Control Panel
(Data Out)
Data In
G
-
-Aux Pwr (GND)
+
+Aux Pwr
Y
(Data In)
Data Out
APPLICATION GUIDELINES FOR THE 6160RF
Use the following guidelines when planning an installation:
If...
And...
This is the only
You want to use both
transceiver on
the receiver and
the system,
transmitter function
on a single-partition
system,
There is another
You want to use only
receiver or
the transmitter
transceiver on
function on a second
the system,
partition,
You want to use only
the transmitter
function on a single-
partition system,
Notes:
* On VISTA-40 panels and above, wireless keypads (e.g., 5804BD) can only be used on a single partition. This partition is
programmed in field 1*48, and must match the partition assigned to the 6160RF. Wireless keys can be used on more than one
partition, using a House ID programmed in the 6160RF and the devices. In this case, the wireless keys must be assigned to the
same partition as the 6160RF.
** On VISTA-20P panels, the 6160RF will use the House ID programmed in the panel for the partition to which it is assigned.
Wireless keypads can only be used on Partition 1.
PROGRAMMING THE 6160RF
Refer to the following procedure to program the 6160RF:
STEP
1.
Enter the program mode by pressing the [1] and [3] keys simultaneously for
a few seconds within 60 seconds after applying power.
2.
(Keypad Address) Enter the two-digit keypad address. Press the [] key to
continue.
Notes: (1) Refer to the control panel's installation instructions for the
acceptable keypad addresses.
(2) On the VISTA-40 and above the 6160RF's partition
assignment must match the RF keypad partition assignment
programmed in field (1*48).
3.
(Receiver Enable) Enter [1] to enable, or [0] to disable Receiver. Enable the
receiver if RF transmitters or wireless keypads are programmed into the
control and no other receivers are enabled. Press the [] key to continue.
Wire Color
Green
Black
Red
Yellow
Then...
•
Set the keypad to a device address assigned to the desired partition.*
•
Enable the receiver.
•
Program a system House ID in the control panel (this will enable the transmitter
function).**
•
Set the wireless devices that will communicate with this 6160RF to the same
system House ID.
•
Set the keypad to a device address assigned to the desired partition.*
•
Disable the receiver.
•
Program a DIFFERENT House ID in the 6160RF than is programmed in the control
panel.*/ **
•
Set the wireless devices that will communicate with this 6160RF to the same
House ID as the 6160RF.
•
Set the keypad to a device address assigned to the Partition 1.
•
Disable the receiver.
•
Program a House ID in the 6160RF that matches the system House ID
programmed in the control panel.*
•
Set the wireless devices that will communicate with this 6160RF to the same
House ID.
DESCRIPTION
- 2 -
5. Reattach the keypad to the mounted case back. Attach
the top of the keypad first, and then press the bottom
section down until it snaps into place securely.
6. Peel off protective film on the LED panel and install the
keypad labels as required.
CON ADDRESS
= XX
RECEIVER
ON [0= OFF]
DISPLAY
CHOICES
00-31
1= ON
0 = OFF
Advertisement
