Reboot; Initialize - Buffalo BS-MP20 Series User Manual

Reboot

Reboot the switch.
Reboot System

Initialize

Restore the switch settings to the factory default.
Initialize Except IP
Address
Initialize All Settings
Physical Reset Button
Notes:
• If the physical reset button is enabled, the switch can be initialized by pressing and holding the button for 3
seconds until the diag LED turns red.
• If the physical reset button is disabled and you forgot the username or password for Settings, contact our
technical support.
Click Reboot to reboot the switch.
Click Initialize to initialize all settings except the switch's IPv4 address.
Click Initialize to initialize all switch settings.
Enable or disable the reset button on the switch.
37