Speed/Mode Settings - Buffalo BS-MP20 Series User Manual

Speed/Mode Settings

Configure ports settings such as the transmission rate or flow control.
Name
Admin
Mode
Flow Control
IEEE 802.3az
APD
Jumbo Frame
Speed/Duplex
Enter the port name. You may enter up to 15 alphanumeric characters, hyphens (-),
underscores (_), and spaces.
Check to enable the port.
Select the transmission rate and duplex from below.
Autonegotiation
The transmission rate (max 10 Gbps) and duplex status will be configured
automatically depending on the connected device. Select this during normal
operation.
100M bps Full
The transmission rate will be fixed at 100 Mbps. And the duplex status will be fixed
at full.
Autonegotiation (5G)
The transmission rate (max 5 Gbps) and duplex status will be configured
automatically depending on the connected device. Select this if the switch cannot
communicate with the connected device when "Autonegotiation" is selected.
Autonegotiation (2.5G)
The transmission rate (max 2.5 Gbps) and duplex status will be configured
automatically depending on the connected device. Select this if the switch
cannot communicate with the connected device when "Autonegotiation" or
"Autonegotiation (5G)" is selected.
Check to enable flow control.
Check to enable IEEE802.3az.
Check to enable APD (auto power down). If enabled, power consumption of link
down ports can be reduced.
Check to enable jumbo frame settings.
Displays the current transmission rate and duplex.
23