Installing The Turbocharger - ABB A135-M56 Operation Manual

Operation Manual / 4 Product description / A130-M.. - A145-M..
2 Removing and Installing
2.3

Installing the turbocharger

2.3.1 Inserting gaskets
Inserting the gaskets
Damaged or improperly inserted gaskets lead to oil leaks.
Always use new gaskets and insert them carefully into the slot.

CAUTION
The oil is supplied (02) and drained (03) through the bracket (01).
The necessary sealing is provided by O-rings. The gaskets are not included in the ABB Turbo
Systems scope of delivery and must be provided by the enginebuilder.
Figure 9: Inserting gaskets into the bracket
01 Bracket
02 Oil supply
03 Oil drain
Pin (06) as installation safety device
Turbochargers can have an oil inlet either on their right or left side; the oil
inlet position can be different for the turbocharger fitted on the left and on the
NOTICE
right engine bank.
A pin can be installed in the support as an installation safety device to pre-
vent inadvertent incorrect fitting. This pin fits into the respective slot on the
foot of the bearing casing. Instructions of the enginebuilder must be ob-
served.
© Copyright 2016 ABB. All rights reserved.
04 Slot for gasket
05 O-rings
06 Pin (optional)
HZTL4031_EN
Page 16 / 117
Revision D June 2016