Checking For Blockages - Shark ROCKET PowerFins UZ360 Series Owner's Manual

MAINTAINING YOUR VACUUM
FLOOR NOZZLE
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
POWERFINS FLOOR NOZZLE
1. Turn off the vacuum.
2. Using a coin, turn locks counterclockwise to
open, then lift off cover to access brushroll.
3. Clear airway of blockages.
4. Replace cover by sliding inserts into slots, then
pressing down firmly on all sides before turning
locks clockwise to close. When the locks are
securely closed, they will click into place.
CLEANING THE POWERFINS BRUSHROLL
If any hair is wrapped around the brushroll, continue
cleaning, using the Carpet setting on a bare floor
surface, a low-pile carpet, or a small area rug. If
some fibers remain after continued use, carefully
remove them from the brushroll.
s h a r kc l e a n . c o m
MAINTAINING YOUR VACUUM

CHECKING FOR BLOCKAGES

Checking for Blockages in the Handheld Vacuum:
1. Turn off vacuum.
2. Remove the handheld vacuum from the wand.
3. Check all intake openings to the dust cup and
remove any debris or blockage.
Checking for Blockages in the Wand:
1. Turn off vacuum.
2. Remove the handheld
vacuum and floor
nozzle.
3. Clear away any debris
and blockages inside
the wand.
Checking for Blockages in the Floor Nozzle:
1. Turn off vacuum
2. Detach the wand
3. Use the edge of a coin to open the three l
ocks on the bottom of the floor nozzle
4. Remove the cover and tilt back the neck
of the floor nozzle
5. Check the opening and remove any debris or
blockages
6. Replace cover by firmly pressing down on all
sides and turning the locks clockwise to close
s h a r kc l e a n . c o m