Service; Pace Worldwide Limited Warranty Statement - Pace TD-100 Operation And Maintenance Manual

5. Remove and replace the old O-ring from the connector assembly (Old "O-ring" may remain in
handle)
6. Reinstall the connector assembly. Be sure to line up the keyways on the handle and connector
assembly. Do not force the connector assembly into the handle.
7. Reinstall the cap and make sure it is fully seated against the handle
8. Install a tip cartridge
The O-rings on the MT-100 do not need to be replaced.
Handpiece Troubleshooting
Most malfunctions are simple and easy to correct.
Symptom
Handpiece will
not heat

Service

Please contact PACE or your local distributor for service and repair.

PACE WORLDWIDE LIMITED WARRANTY STATEMENT

Seller warrants to the first user that products manufactured by it and supplied hereunder are free of
defects in materials and workmanship for a period of three (3) years from the date of receipt by such user.
This Warranty as applied to blowers, motor pumps, x-ray tubes, lenses, optical/lighting probes and
cameras is limited to a period of one (1) year. Monitors, computers and other brand equipment supplied
but not manufactured by PACE are covered under their respective manufacturer's warranty in lieu of this
Warranty.
This warranty does not cover wear and tear under normal use, repair or replacement required as a result
of misuse, improper application, mishandling or improper storage. Consumable items such as tips,
heaters, filters, etc. which wear out under normal use are excluded. Failure to perform recommended
routine maintenance, alterations or repairs made other than in accordance with Seller's directions, or
removal or alteration of identification markings in any way will void this warranty. This warranty is
available only to the first user, but the exclusions and limitations herein apply to all persons and entities.
SELLER MAKES NO OTHER WARRANTY, EXPRESS OR IMPLIED, AND MAKES NO WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Seller will, at its option, repair or replace any defective products at its facility or other location approved by
it at no charge to user, or provide parts without charge for installation by the user in the field at user's
expense and risk. User will be responsible for all costs of shipping equipment to Seller or other location
for warranty service.
EXCEPT FOR THE REMEDY ABOVE DESCRIBED, UNLESS OTHERWISE REQUIRED BY
APPLICABLE LAW, SELLER WILL HAVE NO OTHER OBLIGATION WITH REGARD TO ANY BREACH
OF WARRANTY OR OTHER CLAIM WITH RESPECT TO THE PRODUCTS, OR LIABILITY FOR ANY
DIRECT, INDIRECT, CONSEQUENTIAL, OR INCIDENTAL LOSS OR DAMAGE CAUSED BY OR
OCCURRING IN CONNECTION WITH ANY OF THE PRODUCTS.
Warranty service may be obtained by contacting the appropriate PACE Company or local Authorized
PACE distributor as set forth below to determine if return of any item is required, or if repairs can be made
by the user in the field. Any warranty or other claim with respect to the products must be made with
sufficient evidence of purchase and date of receipt, otherwise user's rights under this warranty shall be
deemed waived.PACE Incorporated retains the right to make changes to specifications contained herein
at any time, without notice. Contact your local authorized PACE Distributor or PACE Incorporated to
obtain the latest specifications.
©2012 PACE Inc., Southern Pines, North Carolina
All Rights Reserved
Probable Cause Solution
Defective Heater Change Tip Cartridge
Power Source Contact PACE
Malfunction
O-Ring has come Check inside handpiece for Oring. Make sure that
out and blocked tip it has not dislodged or come out of the slot.
from going all of the
way in
Limited Warranty
Tip Cartridge
Page 10 of 11