Table of Contents
Advertisement
®
1. Quick Start Instructions for Single Pilot AGC Operatation
1.
Remove the RF module cover and install the DSIM-SS AGC module into the amplifier.
2.
If the DSIM-SS has a slope POT use it to set the inter-stage slope
3.
Check and set desired amplifier levels.
4.
Re-install the RF module faceplate
5.
Plug the controller cable into the DSIM and plug the controller into the cable.
6.
Press mode button once. The controller light will flash blue and red for approximately
45 seconds.
7.
When done, the controller light will have a half second blue blink indicating that the
DSIM is in AGC mode.
8.
Remove the controller from the amplifier, and the DSIM is all set!
Page 2 of 18
DSIM-SS
Installation Guide Rev B
Advertisement
Table of Contents
