aci DSIM-SS Installation Manual page 11

The DSIM will now go thru the alignment process. The LED on the controller will flash
blue and red (about 45 seconds) until the alignment process has completed.
11. When the alignment process has completed, the controller LED will blink blue
indicating that the DSIM is now in the AGC mode. If the LED does not change to
blinking blue, and instead DSIM LED flashes blue and orange the pilot signal is either
too high or too low going into the DSIM. Check the output signal to verify that you have
the correct output levels and also verify that the pilot channel is present and the correct
type of digital or analog. Press the mode button 2 times and then go back to step 11.
12. Check the LED on the DSIM Module to make sure the channel number is right. Refer to
section 9 for pilot channel blinking count overview.
13. Remove the controller from the amplifier, and the DSIM is all set!
Page 11 of 18
DSIM-SS
Installation Guide Rev A