JVC LT-42ED82G Instructions Manual page 65

"Dolby Digital" output from the DIGITAL AUDIO OUT terminal
Some digital channels are broadcasted with "Dolby Digital" signals.
In these cases, "Dolby Digital" signals can be output from the DIGITAL AUDIO OUT terminal.
1. Connect an audio system with a "Dolby Digital" decoder. (P. 10)
2. Change the "Digital Audio Output" setting from "PCM" to "Dolby Digital". (P. 53)
When changing the setting, the message "Dolby Digital selected! No analogue audio available" may be
displayed for a few seconds.
Each time the channel is changed to a channel that is broadcast with "Dolby Digital" signals, the message
"Dolby Digital selected! No analogue audio available" may be displayed for a few seconds.
Even if "Dolby Digital" is set, "linear PCM" signals will be output by a channel that is not broadcast with "Dolby
Digital" signals. Set the audio system so that it is compatible with both "Dolby Digital" and "linear PCM". (For
details, refer to the audio system instruction manual.)
Set "Digital Audio Output" to "PCM" in the following cases.
The sound of a channel broadcast with "Dolby Digital" signals cannot be heard even when "Dolby
Digital" is set.
When listening with the TV speakers.
When listening with an audio system that does not have a "Dolby Digital" decoder.
When listening with an audio system that is connected to the AUDIO OUT terminal.
When recording a programme.
When "(Dolby)" is displayed in the "Audio Selection" menu (P. 34), selecting "(Dolby)" will change
the "Digital Audio Output" setting to "Dolby Digital" temporarily.
A message recommending you to change the "Digital Audio Output" setting to "Dolby Digital" is displayed for a
few seconds.
If you want to record a "Dolby Digital" signal using timer-record (P. 49), change "Audio" of the
timer-record setting from "PCM / Analogue" to "Dolby Digital". However, if the setting is changed
to "Dolby Digital", you cannot record analogue sound with a recording device that is connected to
the EXT-2 terminal.
"Dolby" and the double-D symbol are trademarks of Dolby Laboratories.
Updating
The TV will run the reception test (for digital channel) at midnight (3AM) on a daily basis.
the PR
If the TV detects channels that became receivable or if the TV was not able to receive a certain channel, a
List
message about updating the PR List will be displayed when the TV is turned on.
The reception test will only operate when the TV is in standby. It will not operate when the TV is turned on.
The reception test will not operate when "Receiver Upgrade" (P. 53) is set to "Manual".
If the TV does not detect any channels that need to be updated, a message will not be displayed.
Services have changed.
Do you want to update PR list?
Yes
To update the PR List right away
A select "Yes"
To update the PR List later
A select "No"
Updating the PR List (Digital channel only)
No
B next
B close
Run the "Service Scan" (P. 55)
The "Service Scan" will take a few minutes.
Next time you turn on the TV, the message will not
be displayed. But you can update the PR List using
"Service Scan" (P. 55) whenever you want to.
62