Table of Contents
Advertisement
Decoder(EXT-2)
Component Auto
Select
EXT Setting
HDMI Setting
HDMI Setting
HDMI CEC
On
HDMI- 1
Size
Auto
Audio
Auto
HDMI- 2
Size
Auto
Attenuator
PC Position
PC Position
Auto
Demonstration
Select "On" when connecting the Decoder to EXT-2 through the
VCR (On / Off)
Changes the TV input to "EXT-4" when a component signal is input
to EXT-4 (On / Off)
Not available when viewing PC
"Setting external terminals" (P. 29)
g
Size :
If picture size is not correct in 480p(525p), change this setting to 1
or 2. Normally set to "Auto".
Audio :
If there is no sound, change this setting to "Digital" or "Analogue".
Normally set to "Auto".
HDMI CEC :
If you use a HDMI CEC compatible device, set this setting to "On".
For more details
"What is "HDMI CEC"?" (P. 63)
g
Select "On" when digital channels are not received because of too
strong radio waves (On / Off)
Note
"Attenuator" attenuates the radio waves of analogue broadcast as well as
those of digital broadcast. If some noise or snow appears when watching
an analogue channel, please set "Attenuator" to "Off" temporarily.
Adjust the position of the PC image
adjust
Starts the "100Hz Clear Motion Drive" demonstration (On / Off)
(P. 64)
Reset
(blue)
46
Advertisement
Table of Contents
