Electrolux WASL6IE300 User Manual page 50

50 www.electrolux.com
Problem
Excessive consumption
of salt.
The drum is empty and
the display shows there
is some weight in.
The drum is full but the
display shows 0.0 kg.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
17.3 Emergency door opening
In case of power failure or functioning
failure the appliance door remains
locked. The washing programme
continues when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock function.
Before opening the door:
CAUTION!
Risk of burns! Make sure
that the water temperature
is not too high and the
laundry is not hot. If
necessary, wait until they
cool down.
CAUTION!
Risk of injury! Make sure
that the drum is not
rotating. If necessary, wait
until the drum stops
rotating.
Possible solution
• Check if the water softener has been set to act also dur‐
ing rinse phase. Refer to "How to set the water hard‐
ness level" in "The Water Softener (SoftWater Technol‐
ogy)" chapter.
• Press the On/Off button to deactivate the appliance and
activate it again to set a tare.
• You loaded the laundry before activating the appliance.
Press the On/Off button to deactivate the appliance.
• Empty the drum and follow the necessary steps. (Refer
to "Loading the laundry")
To open the door, proceed as follows:
1. Press the On/Off button to switch the
2. Disconnect the mains plug from the
3. Open the filter flap.
4. Keep the emergency unlock trigger
Make sure that the water
level inside the drum is
not too high. If necessary,
proceed with an
emergency drain (refer to
«Emergency drain» in
«Care and cleaning»
chapter).
appliance off.
mains socket.
pulled downward and, at the same
time, open the appliance door.