Table of Contents
Advertisement
Expert software
4.3
Programming the HomeServer via the RS232 connection
How to transfer the changed data directly from the start-up PC to the HomeServer:
1. Disconnect the HomeServer from the KNX/EIB (if necessary).
2. Connect the serial (RS232) port of the HomeServer to a COM port of the start-up PC.
Use the start-up cable included in delivery for this purpose.
3. Start the Expert software on your start-up PC. Open the sample project with the chan-
ged IP address (if necessary).
4. Select Transfer. The Transfer Project window opens.
5. Select Via serial port.
6. Next to Serial port, enter the number of your serial port (e.g. 1).
7. Activate Transfer all data for Transfer mode.
8. Switch off the HomeServer. Click on Start. Switch the HomeServer on again. The data is
transferred directly to the HomeServer if three double signal tones were heard.
9. After the data has been transferred, disconnect the direct connection between the
HomeServer and the start-up PC.
10.Connect the HomeServer to the KNX/EIB.
32
06.2012/V 2.0
Advertisement
Table of Contents
