Russell Hobbs RHMO10 Instructions & Warranty page 21

Problem
Condensation or
excess water
Paint damage/
peeling
Light not working
Over heating
Potential reason
1. Food that is being
cooked
2. Cooling vents
covered
Maintenance
Bulb not working
Cooling vents covered
Potential solution
Spillages or splashes can burn and catch
fire, all food that is put into the microwave
should be appropriately covered. All
spillages or splashes must be cleaned, and
all areas of microwave cleaned after each
Burnt on food debris in the microwave,
on the waveguide and the behind the
waveguide can cause the microwave to
'spark'. This is because burnt on debris
can be focused on by the microwaves and
Microwaves must be thoroughly cleaned
after every use to ensure no food is burnt
on to any part of the microwave.
Cooling vents allow the heat and steam to
escape from the microwave. These cannot
be covered as it can cause excessive
water to settle inside the microwave or the
microwave to overheat.
The installation instructions in the
instruction manual must be followed or the
warranty will be void.
If the microwave is within its warranty
period, please contact customer services
for further advice or take the microwave
back to the retailer it was purchased from
for a refund or replacement.
Due to the construction of microwaves and
certain 'dangerous' components t he light
bulb can only be changed by a qualified
service engineer.
If the microwave is within its warranty
period, please contact customer services
for further advice or take the microwave
back to the retailer it was purchased from
for a refund or replacement
Cooling vents allow the heat and steam to
escape from the microwave. These cannot
be covered as it can cause excessive
water to settle inside the microwave or the
microwave to overheat.
The installation instructions in the manual
must be followed or the warranty will be
21
use.
spark.
void.