Commissioning (Tower Fan Heater With Remote Control); Standby Mode; Fan Mode; Heating Level Setting (Heating Mode) - Silvercrest STHL 2000 A1 Operating And Safety Instruction

Press the lock on the remote controller bat-
15
tery compartment
14
the battery compartment
2
Remove the used battery
Insert a new type CR2025 3 volt lithium coin
cell using the correct polarity.
Slide the battery compartment
remote controller until the lock
sition.
6. Commissioning (Tower fan heater
with remote control)

6.1 Standby mode

Connect the Tower heater blower to an
earthed, secured wall mains socket. To
supply the appliance with electricity,
put the on/off switch 6 to position "I".
The appliance is then in standby mode
and the display 1 shows the room
temperature.

6.2 Fan mode

Press the on/off key 7 once in standby mode.
The appliance is then in fan mode.
16 GB/IE/NI/MT/CY
to the centre. Then, pull
out (see Image 2).
14
.
16
back into the
14
clicks into po-
15

6.3 Heating level setting (heating mode)

Press the heating level key
mode. The appliance is then in heating
level 1. The tower heater blower has a
heat output of 1200 W. The on/off key
5 is lit in blue.
Press the heating level key
appliance to heating level 2. The tower heater
blower has a heat output of 2000 W. The on/
off key 5 is lit in red.

6.4 Switching the appliance off

Press the on/off key 7 once to switch the appli-
ance off. The fan runs for a further 60 seconds
before going off (a countdown is shown on
the display). The appliance returns to standby
mode. The display shows the room temperature.
To disconnect the towerheater blower from the
electricity, put the on/off switch 6 to position
"O".

6.5 Oscillation function

To switch the oscillation of the appliance
on or off, press the oscillation key
If successfully activated, the oscillation key icon
4 is lit.
The oscillation function has the effect that the air
blown off is distributed from the left to the right.
once in fan
13
to change the
13
.
12