Oscillation Function; Temperature Setting; Timer Setting; Before Commissioning The Tower Fan Heater With Remote Control - Silvercrest STHL 2000 A1 Operating And Safety Instruction

4.5 Oscillation function

To switch the oscillation of the appliance
on or off, press the oscillation key 4 .
If successfully activated, the oscillation key icon
4 is lit.
The oscillation function has the effect that the air
blown off is distributed from the left to the right.

4.6 Temperature setting

Press the on/off key 5 once in standby
mode twice or three times.
Press the temperature key 2 to enter tempera-
ture setting mode.
Press the temperature key 2 repeatedly to
reach the temperature you desire (between 15
and 40 ºC).
After setting the desired temperature, wait 3 sec-
onds. The specification is assumed automatically.
If the temperature has been successfully set, the
temperature key icon 2 is lit .
The integrated thermostat now automatically
switches the heating function on/off.
ATTENTION! When setting the temperature, it must
be observed that the appliance does not heat if the
desired temperature is lower than room temperature
or equivalent to it. To heat, the temperature set must
be at least 1 ºC higher than room temperature. This is
displayed automatically when you switch the remote
controller on.

4.7 Timer setting

The timer is used to switch the tower heat-
er blower off automatically. A switching
off time can be selected in hour steps with
the timer. The tower heater blower then
switches off automatically.
In fan or heating mode, press the timer key 3
repeatedly until you reach the desired number of
hours.
Repeated pressing of the timer key 3 sets the timer
to an hourly step:
If timer setting has been successful, the timer key
icon 3 is lit .
Example: Press the timer key 3 until "
be seen on the display, if the appliance should
automatically switch off after 4 hours. Wait for 3
seconds. The specification is assumed automatically.
The appliance will be switched off automatically in
4 hours.
If you wish to ensure that the timer specification has
been accepted, press the timer key 3 once. "
or your specification is shown on the display.
NOTE: If you set the on/off switch 6 to "O" po-
sition or if the tower heater blower is disconnected
from the electricity supply, the timer and temperature
you have programmed are deleted.
5. Before commissioning tower fan
heater with remote control
5.1 Remote control: Inserting/changing the
battery
When supplied, a lithium coin cell
ed with the remote control. In order to enable
operation of the remote control, remove the
plastic tape which protrudes out of the battery
compartment (see Image 1).
14
1
If the battery in the remote control has to be re-
placed, insert a new 3 volt lithium coin cell. Pay
attention to the lithium coin cell type (CR2025)
here.
" can
"
is includ-
16
GB/IE/NI/MT/CY 15